EIGRP will keep up to_______ feasible successors in the topology table in 15.0 code.
32
What three items must match for a successful EIGRP neighbor discovery process?
1.The AS number, 2.K values and 3.Authedication settings if used
What is the metric of a remote network as reported by an EIGRP neighbor called?
Advertised distance
The _____________ command causes an EIGRP router to stop sending hello packets through an interface.
passive-interface
By default, how many equal-cost routes to the same destination network will EIGRP install in the routing table?
4
What is the administrative distance of externally learned EIGRP routes?
170
Which routing protocol supports unequal-cost load balancing on Cisco routers?
EIGRP
Which two steps must be taken in order to send a default route to other EIGRP routers?
1.Configure a default route and 2.Redistribute the default route.
When a Cisco router is configured with a fast-switching, how are packets distributed over equal-cost paths?
on a per-destination basis
What is the default maximum amount of bandwidth that can be used for exchanging EIGRP messages on an EIGRP-configured interface?
50%
The command to propagate the default route from the router Border to the rest of the EIGRP domain is Border(config-router)#
redistribute static
Which command can be issued on a router to verify that automatic summarization is enabled?
show ip protocols
When an EIGRP-enabled router uses a password to accept routes from other EIGRP-enabled routers, which mechanism is used?
EIGRP authentication
Which EIGRP route would have the preferred administrative distance?
a summary route
Which three metric weights are set to zero by default when costs in EIGRP are being calculated?
K2, K4 and K5
What is indicated when an EIGRP route is in the passive state?
The route is viable and can be used to forward traffic.
Which protocol is used by EIGRP to send hello packets?
RTP
Share:
