Configuring Switch Interfaces

If a user connects a switch to the cable, prevents multiple devices from sending data through the port.

Prevents unknown devices with unknown MAC addresses from sending data through the switch ports.

Will allow any one device to connect to each port, and will save that device’s MAC address into the startup-config

Will allow any one device to connect to each port and will save that device’s MAC address into the startup-config

Correct! Wrong!

Configure the no negotiate interface subcommand

Configure the duplex half interface subcommand

Configure the duplex full interface subcommand

Configure the speed 100 and duplex full interface subcommands

Correct! Wrong!

Setting the maximum number of allowed MAC addresses on the interface with the switchport port-security maximum interface subcommand

Enabling port security with the switchport port-security interface subcommand

Defining the specific allowed MAC addresses using the switchport port-security mac-address interface subcommand

All the other answers list required commands

Correct! Wrong!

The switch discards both the first and second frame.

The switch puts the interface into an err-disabled state when the first frame arrives.

The switch generates syslog messages about the violating traffic for the first frame.

The switch increments the violation counter for Gi0/1 by 2.

Correct! Wrong!

Half duplex

Full duplex

10000 Mbps

10 Mbps

Correct! Wrong!