Learning IPv4 Routes with RIPv2

0%

What is the name of the common Distance Vector (DV) feature that prevents a route from being advertised out the same interface it was learned from?

Correct! Wrong!

Correct! Wrong!

Refer to the diagram. Using the fewest commands, which commands would be used to enable all interfaces on R1 to be included in the RIP routing process?

Correct! Wrong!

Refer to the exhibit; which statement about the output shown is correct?

Correct! Wrong!

Which of the following are features of RIPv2?

Correct! Wrong!

A figure shows a network with all links working. Imagine the routes that each router would use if RIPv2 had been correctly configured on all links. Now analyze the exhibit, which shows the current state, and predict the routes each router should know. Which routers currently use different routes than they would have used if RIP were implemented correctly?

Correct! Wrong!

Which of the following best describes the concept of the RIP hop count metric?

Correct! Wrong!

Which of the following network commands, following a router rip command, would cause RIP to send updates out two interfaces whose IP addresses are 10.1.2.1 and 10.1.1.1, mask 255.255.255.0?

Correct! Wrong!

Correct! Wrong!

Router R2 has interfaces with addresses/masks of 10.1.1.2/24 and 11.1.1.2/24. Which of the following commands would be part of a RIP Version 2 configuration on R2 that enables RIPv2 on both interfaces?

Correct! Wrong!

Correct! Wrong!

Which Cisco IOS command can be used to stop all RIPv2 updates from being sent out a specific interface?

Correct! Wrong!

What is the name of the common Distance Vector (DV) feature that automatically advertises a route with an unreachable metric if a device sees the route as having failed?

Correct! Wrong!

Which Cisco IOS command can be used to disable all RIPv2 updates from being sent out any interface by default?

Correct! Wrong!

Routers R1 and R2 use RIPv2, and should exchange routes with each other. R1 and R2 connect on an Ethernet link, with both routers using their G0/0 interfaces. R2 learns routes from R1, but R1 does not learn routes from R2. Which of the following mistakes could result in this symptom?

Correct! Wrong!

Review the snippet from a show ip route command on a router. Which of the following statements must be true regarding this output? R 10.1.2.0 [120/1] via 10.1.128.252, 00:00:13, Serial0/0/1

Correct! Wrong!

Learning IPv4 Routes with RIPv2